The new user will now appear in the list of users with Remote Desktop access on the Remote Users screen. The specified user will now have remote Terminal Services access to the system. With Terminal Services installed and configured on the server, the next step is to ensure the services can be accessed from a remote client.
Terminal services provides both remote desktop and remote application access. Under remote desktop access an entire desktop session running on the server is displayed on the client.
The user then interacts with the desktop to launch and interact with applications details on installing applications for use with Terminal Services is covered in the chapter entitled Installing Applications for Windows Server Terminal Services.
In the case of remote applications, the remote application running on the server appears in its own window on the client desktop, to all intends and purposes looking like a local application to the user.
With the appropriate configuration tasks completed on the remote system the next step is to launch the Remote Desktop Client on the local system.
This can either be an IP address or a computer name. If previous connections have been established the User name field will be populated with the user name used in the preceding session. If you need to log in as a different user this option will be provided on the next screen which appears after the Connect button is pressed:.
In this screen enter the password for the selected user note that remote desktop access is only available for user accounts which are password protected. If a user other than the one displayed is required, simply click on the Use another account link and enter the necessary details. Click on OK to establish the connection. After a short delay the remote desktop will appear on the local computer screen. When the Remote Desktop Client is exited by pressing the 'X' on the control panel the remote session continues to run on the server even though no client is connected.
Next time the user connects the desktop session will appear exactly as it was left before. To end the session select Start in the remote desktop session, click on the right arrow button in the bottom right hand corner of the menu and select Log Off. This will close down the remote desktop session and close the remote desktop client.
Multiple concurrent remote desktops can be run and managed within a single window using the MMC Remote Desktops snap-in. Leave the default option on the next Add Roles wizard page. We can also add and remove users and users groups from this screen. On the next installation page select this domain if the organization has only one domain in place. Select the second option i. Forest if you have more than one domain in your network.
In case you need this to be placed on some other location, select the Browse option and choose a folder. Review the option that you selected, read about the information and warning messages on the Confirm Installation Selections window and click install. After installation is done a warning will pop up to reboot the system to finish the installation. A description of some of the classes associated with the WMI provider are listed below:.
See Also : Tech Support Show details. You can send users messages, disconnect them from the server , or connect to their sessions remotely.
With Terminal Services Manager you can send bulk messages to users, disconnect idle users, and end sessions of. After you move the CALs, you must deactivate the old license server.
See step Install Terminal Services Licensing on the target server. Activate the license server. The following table lists both the former name and the new name of …. Contents Exit focus mode. Please rate your experience Yes No.
Any additional feedback? Caution This list is an aggregate of common issues seen with Terminal Services in Windows Server
0コメント